TIMED ONLINE ON SITE AUCTION Equipment from Sanitation and Soap Manufacturer including ATEXED rated equipment Location Melksham UK

INGERSOLL RAND RSE SERIES VARIABLE SPEED DRIVE ROTARY SCREW AIR COMPRESSOR MODEL NUMBER: RSE45N-A13 WITH ADDITIONAL I RAND COMPONENTS. RUNNING HOURS: 1085. ON LOAD HOURS: 859. SPECIFICATIONS: - MAX PRESSURE (BARG) : 13 - NOMINAL POWER (KW) : 45 - CAPACITY (FAD)* (M3/MIN) : 6.16 - DIMENSIONS (L) (MM) : 1722 - DIMENSIONS (W ) (MM) : 920 - DIMENSIONS (H) (MM) : 1659 - WEIGHT (KG) : 974 ADDITIONAL: I RAND REFRIGERANT COMPRESSED AIR DRYER I RAND FA SERIES INLINE PRE-FILTER C/W COND DR I RAND FA SERIES INLINE AFTER-FILTER C/W COND DR I RAND VERTICAL AIR RECEIVER I RAND VERTICAL AIR RECEIVER - ZERO LOSS COND DRAIN STERLING CONDENSAT WASTE OIL/WATER SEPARATOR

REVERSE OSMOSIS SYSTEM FULLY PROGRAMMABLE CONTROL PANELS, A 200L RAW WATER TANK WIT - REVERSE OSMOSIS SYSTEM 415V 3-PHASE 32A INVERTER DRIVEN 2.2KW MULTI STAGE GRUNDFOS PUMP 6 OFF 316 STAINLESS STEEL REVERSE OSMOSIS HOUSINGS FITTED WITH 4040 MEMBRANES FOR BRACKISH WATER FLOW CONTROL WITH FLOW AND REJECTION RATE FLOW INDICATOR TUBES FULL WATER QUALITY AND CONDITION SENSOR MANAGEMENT THROUGH CONTROLLERS. THE OVERALL SPEC FOR THE RO UNIT CAPABILITY: PERMEATE FLOW RATE UPTO 1500L/HR MIN SALT REJECTION 97% RECOVERY > 75 OPERATING PRESSURE 8-10 BAR MEMBRANES : 4040 VOLTAGE 415/50HZ MOTOR POWER : 2.2KW FEED WATER CONNECTION DN 20 CONDUCTIVITY RANGE 2-200 US FEED WATER PRESSURE 2-6 BAR MAX FEED WATER TEMP 35 C MAX AMBIENT TEMP 40 C HEIGHT 1650MM WIDTH 700MM LENGTH 700MM DRY WEIGHT 195KG MAINS PRE-FILTRATION 2 OFF 20 FILTRATION SYSTEM UNITS FITTED WITH 50 MICRON FILTERS 4 DIAMETER 2 OFF 20 FILTRATION SYSTEM UNITS FITTED WITH 10 MICRON FILTERS 4 DIAMETER RAW WATER TANK AND PRESSURE PUMP 200L TANK WITH 0.75KW VARIABLE SPEED PUMP (FITTED WITH BULLET PRESSURE CONTROL) 230V SINGLE PHASE WASTE WATER TANK 150L ENCLOSED PALLET TANK FOR WASTE WITH LEVEL CONTROL 0.37KW WASTE PUMP 230V/50HZ SOFTENERS/CARBON FILTERS DUPLEX WATER SOFTENERS WITH CLACK CONTROL SYSTEM 230V SINGLE PHASE 2A SUPPLY TO 12V CONTROL CARBON WATER FILTRATION UNIT WITH CLACK CONTROL HEAD FILLED WITH ACTIVE CARBON GRANULES 230V SINGLE PHASE 2A SUPPLY TO 12V CONTROL FINAL POLISHING UNIT 150L PRESSURE VESSEL FOR POLISHING TO ENSURE QUALITY PROGRAMMABLE CONTROLLER CONTROL PANEL FITTED WITH SIEMENS LOGO CONTROLLER FOR PUMP START, LEVEL CONTROL AND OVERALL CONTROL OF THE SOFTENERS AND TANKS (RAW, WASTE, STORED GOOD WATER) THE MAIN CONTROL PANEL IS 32A 3PH 50HZ SIEMENS LOGO PROGRAMMABLE CONTROLLER WITH HMI INTERFACE (FULLY PROGRAMMABLE) SCHNEIDER CONTACTORS, OMRON RELAYS FOR THE VARIOUS SIGNALS TO AND FROM THE TANK AND CONTROL OF PUMPS/SYSTEM. (TWO 25KG BAGS OF SALT AND A COUPLE OF FILTERS INCLUDED)

ALMIG ACTIV-AIR COMBI 18-8-500-D COMPACT AND ECONOMICAL AIR COMPRESSOR. 122 ON LOAD HOURS - ALMIG ACTIV-AIR COMBI 18-8-500-D COMPACT AND ECONOMICAL AIR COMPRESSOR. RUNNING HOURS: 887 ON LOAD HOURS: 122

ROBOPAC MASTERPLAT LOW PROFILE PALLET WRAPPING MACHINE WITH 270-DEGREE RAMP. THIS MACHINE FEATURES A 1650MM TURNTABLE DIAMETER, SUPPORTS PALLET LOADS UP TO 2200KG, AND WRAPS PALLETS AS TALL AS 2000MM. CUSTOMIZABLE SETTINGS INCLUDE UPWARD-DOWNWARD CYCLES, TOP AND BOTTOM WRAPS, REINFORCEMENT WRAPS, CARRIAGE SPEED AND TURNTABLE SPEED. ADDITIONAL FEATURES INCLUDE AN EMERGENCY STOP, IP54-RATED PROTECTION, FORK LIFTING SLOTS AND PHOTOCELL HEIGHT DETECTION. THE MASTERPLAT PLUS PGS IS THE RELIABLE, EFFICIENT SOLUTION FOR ALL YOUR PALLET WRAPPING NEEDS.

EDURAMAXX 17,000L PURIFIED WATER STORAGE TANK. PUMPS AT FRONT AND REAR ARE NOT INCLUDED. ALL REMAINING CABLING AND/OR EQUIPMENT MUST BE MADE SAFE AND LEFT IN GOOD CONDITION, IN COMPLIANCE WITH RELEVANT SAFETY REGULATIONS.

LARGE CONFERENCE TABLE, 10 X BLACK METAL MEETING CHAIRS AND 2 X CABINETS

THREE BAYS OF PALLET RACKING

5 X ROUND WHITE TABLES - 5 X GREEN CHAIRS - 5 X BLUE CHAIRS - STORAGE CABINET

THREE BAYS OF PALLET RACKING

3 X 4-PART FULL-HEIGHT LOCKERS, 2 X 2-PART FULL-HEIGHT LOCKERS, 1 X SINGLE FULL-HEIGHT LOCKER, 1 X PPE STORAGE LOCKER, 3 X 5-COMPARTMENT LOCKERS, CHANGING ROOM BENCH.

THREE BAYS OF PALLET RACKING

THREE BAYS OF PALLET RACKING (STOCK IN PHOTO IS NOT INCLUDED).

BS80D HYDRAULIC SCISSOR LIFT TABLE, CHADWICK PUMP TRUCK

[VITAI VT-8800 CRYSTAL RADIOS] [VITAI 6-WAY MULTI-UNIT CHARGER] SOLD AS SEEN.

DRIVE MOBILITY SCOOTER WITH CHARGER INCLUDED (MISSING KEY, SOLD AS SEEN)

A HMI CONTROL PANEL WITH A MOTOR CONTROL CENTER (MCC). VOLTAGE: 400V FREQUENCY: 50HZ TOTAL FLA: 165A SUPPLY FUSE: 200A PHASES: TPNE LARGEST MOTOR FLA: 40A

WESTERN AIR DUCTS EXHAUST VENTILATION SYSTEM FOR ATEXED PLANT FUME EXTRACTION-70M - FAN (6,500M/HR) - WESTERN AIR DUCTS EXHAUST VENTILATION SYSTEM FOR ATEXED PLANT FUME EXTRACTION. A CENTRIFUGAL EXTRACTION FAN CAN BE FOUND LEFT OF THE FRONT SHUTTERS OF THE WAREHOUSE. AIR DUCTS RUN FROM THE FRONT OF THE MAIN WAREHOUSE, THROUGH TO THE STORAGE ROOM AND CONNECTS UP TO MOST OF THE MACHINERY. SPECIFICATIONS OF EXTRACTION FAN: ATEX CAT2G (INTERNAL) CERTIFIED CENTRIFUGAL EXTRACTION FAN, CAPABILITIES OF EXTRACTING 6,500M3/HR @ 160MM WG. APPROXIMATELY 70M OF DUCTING.

MEZZANINE CONVEYOR BELT (APPROX. LENGTH 5M) WITH CONTROL PANEL. INCLUDES CONTROL PANEL WITH START/STOP BUTTON AND EMERGENCY STOP. S/N:

[2000L] STAINLESS STEEL MIXING/HOLDING TANKS WITH A STAINLESS STEEL BULK IBC FILLING STATION - A 5,000L AND A 1,000L STAINLESS STEEL (316L GRADE) MIXING TANKS WITH TOP MIXERS AND ONLINE HOMOGENISERS. A 10,000L AND A 5,000L STAINLESS STEEL (316L GRADE) HOLDING TANK, BOTH WITH A TOP STIRRER. A IBC FILLING STATION WITH SIEMENS TOUCH CONTROL PANEL WITH SAFETY SWITCHES. A STAINLESS STEEL WORKING ACCESS PLATFORM.

CIP SYSTEM CONSISTING OF THREE 2000L STAINLESS STEEL TANKS. STORAGE TANKS BY MOESCHLE - STAINLESS STEEL - EXHAUST AIR DUCTS AND ANY STOCK IS NOT INCLUDED

2000L MAX LOAD STAINLESS STEEL MIXING TANK

30,000 LITRE FULLY BUNDED ATEX RATED HORIZONTAL STORAGE TANK. - FULLY ENCLOSED HORIZONTAL BUNDED TANK, 30,000L - MADE FROM 304 STAINLESS STEEL/MILD STEEL BUND - DIMENSIONS (L X W X H) 8700MM X 3.0M X 3.3M - APPROXIMATE WEIGHT 8700KG TANK CONNECTIONS TO INCLUDE: - 2" BOTTOM OUTLET C/W MANUAL VALVE IN BUND AND EXTERNAL MANUAL VALVE - 3" TOP OFFSET FILL CONNECTION C/W VALVE AND COUPLING - TOP ESCAPE MANWAY ACCESS WITH GASKET - VITON - TOP SCREW CONNECTION FOR LEVEL GAUGE - DIGITAL ATEX RATED CALIBRATED GAUGE - TOP FLAME ARRESTOR - EARTHING POINTS FOR TANKER AND TANK TO GROUND - 2" RE-CIRC LOOP IN CASE OF PUMP FAILURE

17,000 LITRE VESSEL WASTEWATER BUNDED TANK - THE TANK IS FABRICATED USING BLACK PIGMENTED HIGH DENSITY POLYETHYLENE (HDPE), PE100 GRADE TO PRODUCE A HIGHLY CORROSION RESISTANT TANK. - RESISTANT TO 60 TEMPERATURE. - TANKS DESIGNED TO HAVE A 20,000 LITRES WORKING CAPACITY WITH 10% FREE BOARD. THE TANK HAS A FLAT BOTTOM WITH A CLOSED CONE TOP. - THE WASTEWATER VESSEL CHARACTERISTICS: - TEMPERATURE OF THE VESSELS ARE TO BE ROOM TEMPERATURE WITH NO COOLING OR HEATING SYSTEM. - PRESSURE TO BE ATMOSPHERIC WITH AN OPEN VENT. TANK FITTINGS: - 2 DIAMETER BOTTOM OUTLET FLANGE COMPLETE WITH ALFA LAVAL LKB-F AUTO VALVE WELD END CONNECTION. - HIGH LEVEL, MID-LEVEL AND LOW LEVEL PROBE TYPE IFM LMTXXX, LENGTH AND MEDIA TO SUIT, WITH HYGIENIC ADAPTER ON TANK TOP. - SUITABLE SAMPLE VALVE IN TANK SHELL. - ACCESS MANDOOR COMPLETE WITH REMOVABLE GRILL ON TANK TOP, TO INCLUDE A PROXIMITY SWITCH. - 4 180 DEGREE VENT (REMOVABLE) COMPLETE WITH ANTI INSECT GRILL ON TANK TOP. - 1 OFF 2 NOZZLES WITH FLANGE CONNECTIONS ON TANK TOP. - VESSEL NAME AND TEST PLATE

NILFISK MAXXI II WET AND DRY VACUUM AND A NILFISK SC401 WALK-BEHIND FLOOR SCRUBBER DRYER.

2017 CEMP 0722 TUV IT 14 ATEX ELECTRIC MOTOR AIR PUMP. ATEX RATED MOTOR HOUSING - AN AS NEW CEMP 0722 TUV IT 14 ATEX ELECTRIC MOTOR AIR PUMP (NEVER BEEN USED). A CEMP 0722 TUV IT 14 ATEX 065 X N2017398328Y20 ELECTRIC MOTOR AB70R 90L 3~ EX DB IIB T4 GB PUMP SPECIFICATIONS: - 3-PHASE GEAR PUMP - 180 L/M FLOW RATE 1.0 BAR DISCHARGE PRESSURE - ATEX RATED MOTOR HOUSING - 2" FITTINGS - GEAR/SHAFT CHROME PLATER WITH CAST IRON HOUSING - VISCOSITY RANGE OF UP TO 50,000 CST S/N: 065 X N2017398328Y20

2 X OFFICE CHAIRS, 2 X LOUNGE CHAIRS, OFFICE DESK AND A SMALL SIDE DRAWER, CUPBOARD IN THE ADJECENT ROOM (FITTED FURNITURE NOT INCLUDED).

SHELVES, CHAIRS, CONTENTS OF SHELVES AND OTHER ITEMS.